Quick Answer: How Long After Adding Algaecide Can You Shock?

Can you over shock a pool?

Although, if you overdo the shock treatment, you risk getting green hair from chlorine due to the excess chlorine oxidizing the copper in the water.

You can execute a shock treatment with a few different types of pool shock, just be mindful of how much you’re using..

Can I shock a pool with chlorine tablets?

How much chlorine do you need to shock a pool? Unfortunately, you can’t shock your pool using your regular 3-inch chlorine tablets. Common chlorine sanitizing products are great for maintaining chlorine levels, but not necessarily eliminating new waste, bacteria and algae.

Can too much shock make your pool cloudy?

Sometimes you’ll get cloudy pool water after shocking. This is common and should dissipate over time. Just keep your filter running and it should clear up. Also, look into a new brand of shock (make sure you buy shock that has a main active ingredient of calcium hypochlorite).

What happens if stabilizer is too low in pool?

If your CYA levels dip too low, your chlorine will be completely gone in a few hours and your swimming pool will become susceptible to bacteria and algae growth. If the pool stabilizer levels get too high, however, it overpowers the chlorine and makes it less effective.

Can I put algaecide in with shock?

It Should Not Be Done Together. While shocking and adding algaecide is effective in getting rid of algae, it should not be done together. This is because when you mix chlorine and algaecide together, it renders both of them useless. … Only then should you introduce algaecide to get the best results.

Can you shock your pool and add stabilizer at the same time?

You can even get it mixed in with chlorine tablets or sticks, called trichlor, and in chlorine shock, called dichlor. These combination products are referred to as stabilized chlorine because the stabilizer is mixed right in with the sanitizer, saving you the trouble of measuring and adding them separately.

How long after you shock your pool will it clear up?

Always run the pump when shocking the pool and allow it to circulate for 24 hours. The water should then be a blue or cloudy blue color. Test the water 24 hours after shocking and start adjusting pH and alkalinity levels. The chlorine will still be elevated, but over a few days it should stabilize.

Why is my pool still green after shock and algaecide?

In many cases where pools are still green after spending hundreds of dollars on chemicals, the filter sand or filter cartridges needs replacement, or the DE grids are clogged or damaged. Filter Cleaners can rejuvenate filter media, but there comes a time when it needs to be replaced, just like an air filter.

Can I add shock and chlorine at the same time?

Yes, you can add both shock and chlorine to a pool. However, you should not add them at the same time. The best thing to do is to shock your pool first. Then, once the chlorine levels go down to a certain threshold, you can add more chlorine.

What happens if you go in a pool that was just shocked?

The type of shock treatment you use in your pool and the amount of time you wait will determine what happens if you swim in a shocked pool. … If you enter the pool immediately following a chlorine pool shock treatment, you are risking as little as skin and eye irritation and as much as fatality.

Can I shock my pool 2 days in a row?

Will the children swim again? Here’s the deal. It’s pretty tough to over-shock your pool; shocking your pool two days in a row with the proper dosage for your pool volume shouldn’t be a problem – and in fact, is sometimes even needed to rid your pool of algae and other contaminants.

Can I add shock and muriatic acid at the same time?

Perhaps most important note of all, never add chlorine and muriatic acid together in the pool. This creates a dangerous toxic gas that can have severe health consequences if inhaled.

How long after using algaecide can you shock?

Keep your pump and filter running. Give the shock a good 12 to 24 hours to work it’s magic. If the algae hasn’t cleared up after 24-48 hours, clean and brush the pool and add another shock treatment.

Why is my pool still green after adding chlorine?

Both are responsible for eating up your available chlorine which can turn into a green pool. … So make sure you’re putting enough chlorine in your water to keep it clear! Too High Cyanuric Acid Level: This is probably the NUMBER ONE reason people have green pools after adding chlorine.

Should filter be on when shocking pool?

While shocking your pool will help kill any germs any algae, it won’t actually get rid of them; for that, you need your filter. So be sure to run your pool filter for at least 24 hours.

When should I add stabilizer to my pool?

The product is typically added to the pool when it is first opened for the summer season. Open your pool under normal procedures, and let the filter run with its normal amount of chemicals. When all the other chemicals, such as chlorine. pH and alkalinity, are balanced, add the chlorine stabilizer.

How do you ruin a pool?

Here are six common ways that pool owners damage their pools.Tearing the Pool Liner. … Not “Winterizing” the Pool or Spa Properly. … Not Maintaining Proper Ph and Alkalinity. … Not Brushing the Sides. … Adding Shock Directly Into the Filter. … Adding Shock Directly to the Water.