Question: What Causes A Front Load Washer To Not Spin?

Why does my washing machine spin then stop?

A clogged drain trap can be a common non-mechanical reason for a front-load washer to stop spinning.

Lint and small items that have been left in pockets or inadvertently picked up with the laundry may collect in the drain trap..

Why are my clothes too wet after the spin cycle?

Drain Hose Issues The most likely culprit for a washer that spins but still turns out soaked clothing is a drain hose problem. It could be clogged, kinked, or even positioned incorrectly if you had to remove the drain tube to make another repair already.

How do you fix a washer dryer that will not spin?

Broken Drive Belt To fix this issue, turn the drum by hand. A working belt should provide some resistance, so if the drum turns very easily and loosely, the belt is probably broken. Unplug your dryer and remove the lid so you can inspect the belt to confirm that it’s broken.

How do I know if my washing machine belt is broken?

When the belt has broken, the washer will fill with water and function normally except the basket won’t spin. If you want to verify that the belt is bad, you can look inside the washer. Turn off the water and unplug the power cord before you do anything.

How do you know if washing machine motor is broken?

The five most common signs of motor issues are listed below.Washer Won’t Pump or Spin. It may happen that the washing machine fails to pump water in and out, as well as spin. … Pumps, but Won’t Spin. … Washer Won’t Agitate. … Clothes Still Wet. … Problems in Every Cycle.

What causes a Maytag washer not to spin?

One common cause why a Maytag top load washer won’t spin is due to an uneven load or jammed clothing. Larger items or loads tend to settle on one side of the washer drum during a cycle. Try to redistribute the load or remove a few articles of clothing and run the spin cycle on your washer again.

Why is my washing machine drum not turning?

The drum doesn’t turn at all If by any chance the drum is very stiff or has seized up, this is the problem. Either an obstruction has jammed the drum, or the drum bearings or motor have seized up. Take off the drive belt to find out which one it is.